Installation & Assembly

ASSEMBLY INSTRUCTION
NOTE: Please consult a qualified electrician if you are not certain of installation or servicing.
CAUTION: Before starting installation or servicing, disconnect power by turning off the circuit breaker or by
removing the fuse at the fuse box.
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Adjust Chandelier Arms to their proper position.
3. Insert the Plug into Slot. To prevent electric shock, match wide side of Plug to wide Slot. Twist the Central
Column to the Bushing until it is fixed firmly. Fasten the Finial onto the other Bushing.
4. Fasten the Mounting Strap to Outlet Box using the Outlet Box Screws provided.
5. Using two pliers, twist open links at the two ends of the Chain. Hook one link to the Loop and the other link
to the Screw Collar Loop. Close the links. Place a piece of cloth between the pliers jaws and the chain links
to prevent scratching the link finish.
6. Weave the fixture wires up through the Loop, through the Chain, through the Ring, through the Canopy,
through the Screw Collar Loop and through the Nipple on the Mounting Strap.
7. Connect the wire with writing on it from the fixture to the black wire (live wire) from the supply circuit.
Connect the wire without writing on it (with raised ribs) from the fixture to the white wire (neutral wire)
from the supply circuit. Cover the connections using provided wire connectors. Tie ground wires from fixture
and from Outlet Box to the Ground Screw on the Mounting Strap. Position wires back inside Outlet Box.
8. Place the Canopy over the Nipple all the way to the Ceiling and tighten the Ring onto the Screw Collar Loop
until the Canopy is held firmly against the ceiling.
9. Unscrew Socket Rings from Sockets. Place Shades over Sockets, reattach Socket Rings to Sockets to secure
Shades. Insert Bulbs. (Not included).
10. Turn on power.