Installation Manual

15
Feed the pull chain coming from the
switch housing through the off-center
hole in the glass bowl. Then, feed
pull chain coming from the bottom of
the light kit through the center hole
in the glass bowl and the rubber
washer. Secure the glass bowl with
hex nut. Feed the pull chains through
the appropriate holes in the nial cap
and secure with the nial.
Proceed to page 17.
Remove the three switch housing
screws and washers from the switch
housing cap and use them to attach
the switch housing cap to the switch
housing.
Install the two CFL bulbs into the
sockets of the light kit.
6. Install glass bowl.4. Attach the switch housing cap
to the switch housing.
5. Install two A-15 bulbs into the
sockets of the light kit.
Rubber Washer
Finial Cap
Finial
Glass Bowl
Light Kit
Washer
Switch
Housing
Screw
Grommet
Hex Nut
Bulb
LIGHT KIT INSTALLATION - (Bowl Light Kit)
X 3