Installation Manual

16
Remove the three switch housing
screws and washers from the light
kit. Then, connect the single-pin
connectors from the switch housing
and the light kit -- blue to black and
white to white. Using the three switch
housing screws and washers, attach
the light kit to the switch housing.
Loosen the thumbscrews. Insert the
glass shade into the light kit. Then,
tighten the thumbscrews to secure
the glass shade. Note: Hand tighten
the thumbscrews. Over tightening
the thumbscrews may crack the
glass shade.
Proceed to page 18.
3. Install three CFL bulbs into the
sockets of the light kit.
1. Attach the switch housing cap
to the switch housing.
2. Install the glass shades.
Light Kit
Glass Shade
CFL Bulb
Thumb Screw
Switch
Housing
Screw
Single-pin
Connector
LIGHT KIT INSTALLATION - (Multi-Arm Light Kit)
X 3