Installation Manual

17
Remove the three switch housing
screws and washers from the
light kit. Connect the single-pin
connectors from the switch housing
and the light kit -- blue to black and
white to white. Then, use the three
switch housing screws to attach the
light kit to the switch housing.
Loosen the thumbscrews. Insert the
glass bowl into the light kit. Then,
tighten the thumbscrews to secure
the glass bowl. Note: Hand tighten
the thumbscrews. Over tightening
the thumbscrews may crack the
glass bowl.
1. Install the light kit. 2. Install the CFL bulb. 3. Install glass bowl.
Single-pin
Connector
Switch
Housing
Screw
Switch
Housing
Screw
Glass
Bowl
Thumbscrew
Light Kit
Washer
Washer
LIGHT KIT INSTALLATION - (Globe Light Kit)
X 3