Installation Manual

To operate the fan using the remote, press and release the following buttons:

1 - High fan speed

2 - Medium fan speed

3 - Low fan speed

4 - Fan Power - Turns the fan off.

Light Delay Off mode - Press and hold the fan power button (4) for ve seconds,

which will turn off light after one minute. The LED indicator on the remote will ash

four times to conrm mode setting.

5 - Light Control: Incandescent Bulbs - Press light control to turn lights off and on.

Press and hold light control to dim or brighten the lights. CFL Bulbs -Turns the

lights on and off. Note: The dimmer function does not work with CFL bulbs.

6 - D/CFL Switch: Switch should be set to “CFL” to correspond with the included

CFL bulbs. Flip to “D” if you change to incandescent bulbs, which will enable the

dimming function.

Remove the battery cover from the back

of the remote. Insert the battery into

the remote; ensure polarity of battery

matches the polarity indicated in the

battery compartment -- positive (+) to

positive (+) and negative (-) to negative

(-). Replace the battery cover and press

the fan power button on the remote to

ensure the LED indicator illuminates and

the remote turns on the fan.

Note: The remote is synced at the factory.

If remote doesn’t turn on the fan, see

TROUBLESHOOTING (page 22).

2. Operate the remote.1. Install the battery.

REMOTE CONTROL OPERATING INSTRUCTIONS

Front Back

Battery

LED Indicator

Fan Power