Installation Manual

7
Slide the downrod into the yoke at
the top of the motor assembly. Align
the holes, and reinstall the pin and
clip. Then tighten both set screws.
3. Install the downrod into yoke.
Insert the downrod through the
canopy. Then, feed the fan wires
through the downrod.
2. Feed the wires through the
canopy and downrod.
DOWNROD OR ANGLE MOUNTING
Remove the clip and pin from the
downrod. Then partially loosen the
two set screws in the yoke at the top
of the motor assembly.
1. Loosen set screws and remove
the pin and clip from the downrod.
Pin
Downrod
Clip
Set
Screw
Canopy
Downrod
Downrod
Set Screw
Pin
Clip
X 2
X 2