Installation Manual

8
Install the ball end of the downrod
into the opening of the mounting
bracket. Align the slot in the ball with
the tab on the mounting bracket. The
downrod should not rotate if installed
correctly.
Proceed to FINAL INSTALLATION,
on page 10.
Strip 1/2” of insulation from the end
of each wire. Twist the stripped ends
of each strand of wire within the
insulation.
Note: If you didn’t trim the wires
in the Step 4, this step is not
necessary.
6. Hang downrod in mounting
bracket.
5. Strip 1/2” of wire insulation.
DOWNROD OR ANGLE MOUNTING
Failure to align the slot in the ball with the
tab on the mounting bracket may cause fan
to fall, which could result in injury or death.
Depending on the length of downrod
you use, you may want to cut the fan
wires to simplify wiring. After pulling
the fan wires all the way through the
downrod, measure 8” of wire. Cut off
the excess wire using wire cutters
(not included).
4. Trim fan wires 8” from top of
downrod.
Slot
Tab
8 in.