Operation Manual

23
LCD
?
Operation of appliances
MODEL PC 150 TR AND PC 180 TR FUNCTIONS
*+(,-./-,(0122,34(15136)
When the engine battery reaches a voltage below 12V, the
self-discharged battery alarm is automatically activated
and the symbol ref. 9 flashes.
*+(,-./-,(0122,34(7813./-.)
Function not available.
&9:/5/134(0122,34(15136)
When the auxiliary battery reaches a voltage below
11V, the self-discharged battery alarm is automatically
activated and the symbol ref. 8 PC150TR / ref.10 PC180TR
flashes.
*;(19:/5/134(0122,34(7813./-.)
a) with the alternator, by the isolator relay when the
engine is running. When the engine is running, this
function allows the refrigerator, the exterior light etc. to
operate.
b) with the 230V system, by the battery charger
c) with the solar panel, by the solar regulator.
<13-/-.) If the main button is off, the battery is
disconnected from the installation and it can be recharged
only when the engine is running.
<13-/-.)
Battery charging by the system and the solar
regulator can take place only if the control panel is on .
=>?(@>521.,(7>-23>5)
An electronic device cuts out all 12V uses when the
auxiliary battery reaches the minimum level of 10V.
It is possible to restore the uses for one minute by
pressing on the ON / OFF button.
A5,723>-/7(0122,34(/B>512>3)
An electronic device, controlled by the function: key
contact and engine ignition connects the auxiliary battery
to the alternator at a voltage above 13.3V and disconnects
it at a voltage below 12V.
Furthermore, this device controls the relays for the
exterior light which should work only when the engine
is off.
C/55/-.(28,(75,1-(?12,3(21-D)
This function is used when the clean water tank is filled with
water; it indicates the water level during the filling process.
To activate this function, press the button ref. 2 for more than 5
seconds, until the LEDs on the LED display start to flash.
To leave this function, press one of the arrow buttons ref. 1 or 2.
This function activates the LED on the tank filling stopper which
lights up when the tank is full.
(See section entitled “WATER CIRCUIT / Filling”).
%?/5/.82(E9-72/>-(F"G(+HI(%$(>-54J)
In a “night-time” situation, thanks to a sensor located
behind the button ref. 8, the LED back-lighting intensity
is automatically reduced to the level previously set by the
user (to adjust it, press and hold the button ref. 8 for more
than 3 seconds until the desired level is reached).