Operation Manual

33
Operation of appliances
!HEATING PLATE
Various brand-name heating plates are installed in our
different models.
!Operation:
Open the valve of the gas tank, as well as the safety lock
of the cooking plate.
On the cooking plate, turn the corresponding knob from
the closed position (position 0) to the maximum position
(full flame), push the knob in and maintain it in this
position while igniting the burner with a match or lighter.
The knob may be released after around 10 seconds, after
the burner has been lit.
Set according to the heat desired.
(on certain 3-burner models, the most powerful burner is a
different colour) Burners should always be lit without a
cooking recipient on top of them.
!Shutting off:
Turn the knob to the stop position (0).
Close the cooking plate valve.
!
Breakdown:
If the appliance no longer works, turn it off and consult a
specialist.
It is forbidden to use the cooking plate during refilling
of the gas containers or inside a garage.
!Care and cleaning:
This must be done only when the appliance is turned off and
has ooled down.
Do not use abrasive or corrosive products, products based on
chlorine, steel wool or a knife blade.
Do not leave acid or alkaline substances (vinegar, salt, lemon
juice, etc.) on the surface of the cooking plate.
For the surfaces in stainless steel and the enamelled parts,
wash with soapy water or detergent, rinse and wipe.
Use a sponge or a clean cloth.
From time to time, check the combustion air input and clean
it if necessary
.
?
=97 >?:0 The glass covers can break if they are heated. Turn off all burners before closing the cover.
Turn off all the burners and wait until they have cooled to ambient temperature before closing the lid.
=97 >?:0 On the models with a built-in sink and cooking area that includes a glass cover over both these areas, please note
that when the cooking area is being used and the cover over the sink is closed, you must maintain a minimum distance of
10 mm between the pan and the sink cover.