Operation Manual

34
Operation of appliances
If there is any risk of frost, drain the boiler. The guarantee
does not cover any damage caused by frost.
The following describes the user instructions for this
appliance.
However, you will have been provided with specific
instructions for this appliance when your camping car was
delivered. It will give you details of how to make the best
use of your boiler.
!Filling the water heater (see page 36)
Check that the safety / drain valve in the cold water inlet
pipe is closed: lever horizontal, position e.
e = lever in “closed” position
f = lever in “drain” position
!Activation, gas operation
a = rotary “On” switch, gas operation.
b = rotary “Off” switch
c = rotary knob for temperature
selection (a green LED comes on)
d) red LED = “fault”
!!Activation, 230V electric operation
(country option)
g = “Off” rocker switch
h = “On” rocker switch
(a green LED comes on)
The water temperature cannot be pre-selected; it is
limited automatically to around 70°C.
To heat the contents of the water heater more quickly, it can
be heated with gas and electricity simultaneously.
The electric immersion heater is fitted with an
overheating controller. In the event of an anomaly,
de-activate at the controls, wait for 10 mins. and
re-activate.
Our different models are equipped with different types of appliances: simple boilers for heating water only and
combined appliances for heating both water and the mobile home unit.
! @98 7'A 98 7'B46<: 7C
?
i