Operation Manual

47
Your camping car is equipped with :
- a clean water tank,
- a waste water tank (2 on certain models)
Filling
I$)/J)%J'0
The clean water tank is filled through an
opening with a screwon stopper located
on the unit exterior and indicated with a
pictogram.
K+*L!"'0
One of our models is equipped with a traditional filling
system inside the living unit in the kitchen block area
and another specific system outside the unit. Filling
is done under domestic pressure (2.5 – 3 bars) with a
special adaptor that should be placed at the end of the
water input hose. Before filling, the
stopper should
be removed with a special wrench
that is applied to the flange ring
around the opening.
If the control panel is in fill mode.
An LED will light up to indicate that
the tank is almost full and that filling
should be stopped.
Internal power supply
The water supply uses a 12 V electric pump.
Pressurize the pump as follows:
- Check that all taps and mixers are closed (cold water
and hot water).
- Switch on the 12 V pump, using the switch on the
electric control panel.
- purge the cold water and hot water circuits using
each tap or mixer.
- The installation is then ready to operate.
A purge fault (presence of air) may prevent the water
heater from operating.
Clean water tank
When traveling, do not wait until the tank is almost
empty before filling it. For example when filling with fuel,
take the opportunity to fill up with clean water as well.
Some parking areas have a tap, but in any case always be
discrete and diplomatic.
Moreover, more and more communes are offering
specific points with special camping car stations (for
example EURO-RELAIS).
The water in the tank is not drinking water.
! WATER CIRCUIT
Operation of appliances
?