User's Manual

Page 10 of 18 Intimidator™ Spot LED 150 User Manual Rev. 8
Configuration
(DMX)
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product’s channels.
The Intimidator™ Spot LED 150 uses up to 11 DMX channels in its 11-
channel DMX
mode, which defines the highest configurable address to 502.
If unfamiliar with the DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MODE/ESC> repeatedly until 001 shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
DMX
Personalities
The Intimidator™ Spot LED 150 has two DMX personalities, a 6-
channel personality and
an 11-channel personality.
To choose which DMX personality to use, follow the steps below:
1. Press <MODE/ESC> repeatedly until either 11CH (to choose the 11-channel
personality) or 6CH (to choose the 6-channel personality) shows on the display.
2. Press <ENTER>.