User's Manual

ManualsBrandsChauvet ManualsHome Theater SystemChauvet Chauvet Home Theater System 150

Page 14 of 18 Intimidator™ Spot LED 150 User Manual Rev. 8

Configuration

(Standalone)

Set the product in one of the standalone modes to control without a DMX controller.

1. Connect the product to a suitable power outlet.

2. Turn the product on.

Never connect a product that is operating in any standalone mode (either Static,

Automatic, or Sound) to a DMX string connected to a DMX controller. Products in

standalone mode may transmit DMX signals that could interfere with the DMX

signals from the controller.

Sound-

Active

Mode

To enable the Sound-Active mode, do the following:

1. Press <MODE/ESC> repeatedly until one of the following shows on the display:

NASL, NAFA, NStS, or SLAv.

2. Press <UP> or <DOWN> to select NStS.

3. Press <ENTER>.

The product will only respond to low frequencies of music (bass and drums).

Automatic Mode

To enable the Automatic mode, follow the instructions below:

1. Press <MODE/ESC> repeatedly until one of the following shows on the display:

NASL, NAFA, NStS, or SLAv.

2. Press <UP> or <DOWN> to select NASL (for a slow light show) or NAFA (for a fast

light show).

3. Press <ENTER>.

Manual Pan/Tilt

Operation

To select whether you want the Intimidator™ Spot LED 150 to operate with normal

panning or inverted panning, do the following:

1. Press <MODE/ESC> repeatedly until PAn shows on the display.

2. Press <UP> or <DOWN> to select normal pan operation (PAn) or inverse pan

operation (r PAn).

3. Press <ENTER>.

To select whether you want the Intimidator™

Spot LED 150 to operate with normal tilting

or inverted tilting, do the following:

1. Press <MODE/ESC> repeatedly until tiL shows on the display.

2. Press <UP> or <DOWN> to select normal pan operation (tiL) or inverse pan

operation (r tiL).

3. Press <ENTER>.

Pan/Tilt Angle

Range

You are able to restrict the pan and tilt angles on the Intimidator™

Spot LED 150 to

achieve the effect you like.

To select which pan angle range to use, do the following:

1. Press <MODE/ESC> repeatedly until PA54 shows on the display.

2. Press <UP> or <DOWN> to select 540° (PA54), 360° (PA36) or 180° (PA18).

3. Press <ENTER>.

To select which tilt range to use, do the following:

1. Press <MODE/ESC> repeatedly until Ti27 shows on the display.

2. Press <UP> or <DOWN> to select either 270° (Ti27), 180° (Ti18) or 90° (Ti 9).

3. Press <ENTER>.