User Manual
TABLE OF CONTENTS 1. Before you Begin ................................................................................................................ 3 What Is Included .................................................................................................................................... 3 Unpacking Instructions .......................................................................................................................... 3 Claims ....................................................
1. BEFORE YOU BEGIN What Is Included Unpacking Instructions Claims • • • • D-Fi™ Hub Power Supply Warranty Card Quick Reference Guide Carefully unpack the product immediately and check the container to make sure all the parts are in the package and are in good condition.
Product at a Glance Use on Dimmer x Outdoor Use x Sound-Activated x P x DMX Master/Slave Safety Notes User-Serviceable Duty Cycle x P x x x Please read the following Safety Notes carefully before working with this product. They include important safety information about its installation, usage, and maintenance.
2. INTRODUCTION Product Overview Antenna Right View Antenna Storage Left View Display and Control Buttons DC Power In DMX In DMX Out D-Fi™ Hub User Manual Rev.
Product Dimensions 3.2 in 82 mm (Mounting Holes) 4 in 102 mm 2 in 50 mm 1.6 in 41 mm 3.3 in 84 mm Page 6 of 12 D-Fi™ Hub User Manual Rev.
3. SETUP AC Power This product has an auto-ranging external power supply and it can work with an input voltage of 100 to 240 VAC, 50/60 Hz. It runs on 9 VDC, 500 mA. To determine the power requirements for this product (power outlet and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. The listed current rating indicates the product’s average current draw under normal conditions.
4. OPERATION Control Panel Operation To access the control panel functions, use the four buttons located around the display. Please refer to the Product Overview to see the buttons location on the control panel.
Programming and Signal Selection To connect the D-Fi™ Hub to a DMX controller and configure it to transmit to D-Fi™-compatible lights, do the following: 1. Connect the hub to the controller using a DMX cable. 2. Connect the hub to power. If the display shows Transmit Manual , where XX is a value between 01 and 16, the hub is already configured for manual transmission. 3. Press
5. TECHNICAL INFORMATION Technical Specifications Dimensions and Weight Length Width Height Weight 4 in (102 mm) 3.2 in (82 mm) 1.6 in (41 mm) 1.2 lb (0.6 kg) Note: Dimensions in inches rounded to the nearest decimal digit. Power Wireless Thermal DMX Ordering Page 10 of 12 Power Supply Type Range Input Voltage External 100 to 240 V, 50/60 Hz 9 VDC, 500 mA RF Output Refresh Rate Frequency Range 18.5 dbm max range 656 ft (200 m) 40 Hz/s 2.412 to 2.484 GHz Maximum External Temp.
To return a product or request support: • • • • If you live in the U.S., contact Chauvet World Headquarters (see Contact Us). If you live in the UK or Ireland, contact Chauvet Europe Ltd.(see Contact Us). If you live in Mexico, contact Chauvet Mexico (see Contact Us). If you live in any other country, DO NOT contact Chauvet. Instead, contact your distributor of record. Refer to our Web site for contact details of distributors outside the US, United Kingdom, or Ireland. If you live outside the U.S.
CONTACT US WORLD HEADQUARTERS - Chauvet General Information Technical Support Address: 5200 NW 108th Avenue Voice: (954) 577-4455 (Press 4) Fax: (954) 756-8015 Sunrise, FL 33351 Voice: (954) 577-4455 Email: tech@chauvetlighting.com Fax: (954) 929-5560 Toll free: (800) 762-1084 World Wide Web www.chauvetlighting.com UNITED KINGDOM AND IRELAND - Chauvet Europe Ltd. General Information Technical Support Address: Unit 1C Email: uktech@chauvetlighting.com Brookhill Road Industrial Estate World Wide Web www.