User manual

D-Fi™ Hub User Manual Rev. 1 Page 7 of 12
3. SETUP
AC Power
This product has an auto-ranging external
power supply and it can work with an input
voltage of 100 to 240 VAC, 50/60 Hz. It runs on 9 VDC, 500 mA.
To determine the power requirements for this product
(power outlet and wiring), use the
current value listed on the label affixed to the product
’s back panel, or refer to the
product’s specifications chart. The listed current rating indicates the product
’s average
current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product
to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Mounting
Before mounting this product, read and follow the Safety Notes.
Orientation
The D-Fi™ Hub
may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
Rigging
Before deciding on a location for this product
, always make sure that it will be easy to
access the unit for maintenance and programming purposes.
Make sure that the structure onto which you are mounting this product
can support its
weight. See the Technical Specifications for weight information.
When mounting this product overhead, always use a safety cable. Mount the product
securely to a rigging point, whether an elevated platform or a truss.
When rigging this product onto a truss, you should use a mounting clamp
of appropriate
weight capacity.
The product also has 4 teardrop holes located on the back for easy wall mounting.
Mounting Diagram
Mounting Holes
Safety
Hook and
Loop
fastener