User manual

Page 10 of 13 Obey™ D-Fi™ 2.4GHz User Manual (Rev. 1)
RGB Offset
RGB Offest is a built-in color-fade program that will create a serial chase through products
1~4.
1. Press <RGB Fade> and <Auto> at the same time.
2. Use the <Speed Time> fader to set the speed of chase.
3. Use the <Fade Time> fader to set the speed of the fade between colors.
4. Use the <Master Dimmer> to set the desired intensity of the light.
Sound-Active mode will function in RGB Offset mode.
Color Macros
These preset color macros have varying intensities.
1. Select one or more products with the Product Selection (Fixture) buttons <1>
through <4>.
2. Use the <Speed Time> fader to select the color combination desired.
3. Use the <Fade Time> fader to set the speed of the fade between colors.
4. Use the <Master Dimmer> to set the desired intensity of the light.
5. Use the <White Dimmer> to set the desired intensity of the white/amber LEDs.
Color Macros will apply the same color to each product.
Sound-Active mode will not function while Color Macros are operating.
Sound-
Override
This feature will work in RGB Fade, Auto, Chase, and RGB Offset modes and creates a
sound-activated show using the selected auto mode. Sound-Override can be triggered using
the microphone instead of the <Speed Time> fader used for other multi-step modes:
1. Press <Sound> until the LED indicator lights.
2. Adjust the sound sensitivity using the Microphone Sensitivity Adjustment Knob
(<Sensitivity>).
The product will only respond to low frequencies of music (bass and drums).
Sound-Override will not function when the unit is in Preset Mode.
White
or Amber
This all-white or all-amber operating mode can create a stable wash or spot for varying
lighting needs. The only functions that will affect these modes are Strobe-Override and
Blackout.
1. Press the <Manual RGBW> button until the LED indicator lights.
2. Use the <White Dimmer> fader independently to get amber, use all faders to create
white.
Strobe-
Override
This mode will produce flashes of light at regular intervals. These intervals are determined by
moving the dimmer fader.
1. Select one or more products with the Product Selection (<Fixture>) buttons <1>
through <4>. NOTE: Strobe-Override will only affect products that are selected.
2. Make sure the color faders are at positions above 1% for the strobe to function.
3. Press <Strobe> until the LED indicator lights.
4. Use <Speed Time> to select the speed of the strobe.
5. To cancel this mode for all products at once, double-tap <Strobe> until the LED
indicator turns off.
6. To cancel this mode for a single product, make sure <Strobe> is activated and <Fade
Time> is set to fully down. Then press <Strobe> until the LED indicator is off.
When in Strobe-Override, the Obey™ D-Fi™ 2.4GHz’s other operating modes will not
function.