User manual

Obey™ D-Fi™ 2.4GHz User Manual (Rev. 1) Page 7 of 13
3. SETUP
AC Power
The Obey™ 4 D-Fi™ 2.4 has an auto-ranging, external power supply that can work with
an input voltage range of 100~240 VAC, 50/60 Hz; it runs on 12 VDC, 500 mA.
To determine the product’s power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product’s back panel, or
refer to the product’s specifications chart. The listed current rating indicates the
product’s average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0~100% switch.
Mounting
Before mounting the product
, read and follow the safety recommendations indicated in
the Safety Notes.
Orientation
The Obey™ 4 D-Fi™ 2.4 may be mounted in any position; however, make sure
adequate ventilation is provided around the product.
Rigging
Before deciding on a location, always make sure there is easy access to the product.
Make sure that the surface onto which you are mounting the product can support the
product’s weight (see the Technical Specifications).
See the Dimensions drawing for mounting-hole distances.