User manual
Programming
A program (bank) is a sequence of different scenes (or steps) that will be called up one after another.
In the DMX-70 30 programs can be created of 8 scenes in each.
ENTERING PROGRAM MODE
Press the PROGRAM button for 3 seconds until “Program” is displayed. This indicates that the user is
in programming mode.
CREATE A SCENE
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the
controller and each bank can hold 8 scene memories. The DMX-70 can save 240 scenes total.
Action
1) Press and hold the PROGRAM button for 3
seconds.
2) Select a FIXTURE (fixture) to program.
3) Compose a look by moving the FADERS.
(Changes in fixture attribute such as colors
and gobos.) Press PAGE SELECT to
access Channels 17~32 on the faders.
4) To program another FIXTURE press the
FIXTURE button you have just finished
programming then select another FIXTURE
button to program.
5) Repeat steps 2 ~ 4 until you have your look.
6) Adjust the Speed and Fade sliders to
achieve the desired amount of time a scene
will be held in a chase (speed) and the
amount of time allowed for the fixtures to
move from one scene to the next (fade).
7) Tap MIDI/ADD button to prepare to store.
8) Choose a BANK (01~30). Use the Up and
Down arrow Bank buttons to change if
necessary.
9) Select a SCENES button to store. All LED's
will blink 3 times. The display will now
display the bank and scene number that is
stored.
10) Repeat steps 2 ~ 9 to record more scenes.
( Read Important notes on the right ->)
11) To exit program mode, hold the PROGRAM
button for 3 seconds. The controller will
default to a BLACKOUT when exiting
program mode.
Notes
Deselect Blackout if LED is lit.
A FIXTURE button represents one lighting fixture.
You can access channels 17~32 by pressing the Page
Select button. This is necessary for fixtures that use
more than 16 channels of control. When switching
pages it will be necessary to move previously moved
faders up then down to activate.
Pressing the same Fixture button again will hold the
parameters changed for that fixture in the program
scene.
There are 8 scenes available in every bank.
DMX-70 User Manual 11 Revised: 2008-02-21 13:02:14