User manual

Page 4 of 16 Geyser™ RGB User Manual Rev. 6
Product at a
Glance
Use on Dimmer
x
Auto Programs
P
Outdoor Use
x
Fixed voltage (120 V or 230 V)
P
Sound-Active
x
Replaceable Fuse
P
DMX
P
User-Serviceable
x
Master/Slave
x
Safety Notes
These notes include important information about the mounting, usage, and maintenance
of this product; read before using the product.
• Always connect the product to a grounded circuit to avoid the risk of electrocution.
• Always disconnect the product from the power source before cleaning or replacing
the fuse.
• Avoid direct eye exposure to the light source while the product is on.
• Make sure the power cord is not crimped or damaged.
• Never disconnect the product from power by pulling or tugging on the cord.
• If mounting the product overhead, always secure to a fastening device using a
safety cable.
• Make sure there are no flammable materials close to the product when operating.
• Do not touch the product’s housing when operating because it may be very hot.
• Do not mount the product on a flammable surface (linoleum, carpet, wood, paper,
carton, plastic, etc.)
• The product’s nozzle is very hot during operation and it remains hot for a long time
after operation has stopped.
• The fog exits the nozzle at a very high temperature. Keep a minimum distance of
6.5 ft (2 m) from the nozzle to the nearest object.
• Do not use the product as a space heater.
• Do not drink or become in contact with the fog fluid. If you do, call your local
emergency service (911 in the US) for help.
•
Do not add perfume, alcohol, gasoline, or any other flammables to the fog fluid.
• Always make sure that the voltage of the outlet to which you are connecting the
product is within the range stated on the decal or panel of the product.
• The product is for indoor use only! (IP20) To prevent risk of fire or shock, do not
expose the product to rain or moisture.
• Always install the product in a location with adequate ventilation, at least 20 in
(50 cm) from adjacent surfaces.
• Be sure that no ventilation slots on the product’s housing are blocked.
• Make sure there is adequate fog fluid in the machine to prevent pump and heater
damage.
• Never connect the product to a dimmer.
• Make sure to replace the fuse with another of the same type and rating.
• Never carry the product by the power cord or any moving part. Always use the
handles.
• The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate the
product at higher temperatures.
• In the event of a serious operating problem, stop using the product immediately.
• Never try to repair the product. Repairs carried out by unskilled people can lead to
damage or malfunction. Contact the nearest authorized technical assistance center.
• This product is not intended for permanent installation.
• Use only CHAUVET® water-based fog fluid.
•
Drain the tank before transporting the product.
• Keep this User Manual for future use. If you sell the product to another user, be sure to
give this document to the next owner.
• Fog Cleaner Quart (FCQ) was specifically developed by CHAUVET® to clean your
Geyser™ RGB. Make sure you use FCQ regularly to increase the life of your fogger.