User manual

DMX Channel Values
Channel Value Function
1
000 Ù
031
032 Ù 087
088 Ù 143
144 Ù 199
200 Ù 255
Mode
Laser off
Clockw
ise rotating
Counter-clockwise rotating
Oscillating back and forth
Sound-active mode
2
Speed Control
Slow
to fast 000 Ù
255
Troubleshooting
CAUTION: Use of controls, adjustments, or performance of procedures other
than what is specified herein may result in hazardous radiation exposure
1) If the power supply indicator does not light up and the laser does not work, please check if the power
supply and the corresponding parts have the right input electric current.
2) If it is in stand-alone mode operation, the power suppl
y indicator is lit and the laser is not working,
please check if the operation system is set up in Master/Slave mode.
3) If it is in Master/Slave mode, Slave mode is not
working, please check as below:
A. Make sure to set up Master mode for just one unit and all the others are set in slave mode.
B. Make sure to control the unit with a DMX controller.
C. Make sure to use a good quality power cord and connection.
4) If the unit is in DMX mode, the laser cannot be controlled b
y the DMX controller, and the DMX signal
Indicator is not illuminated, please check the following:
A. Make sure to set up the DMX mode.
B. Make sure the DMX cable has a good connection.
5) If it is in DMX mode and the laser cannot be controlled by the DMX controller, but the DMX signal
indicator flashes,
please make sure the DMX controller and the laser have the same DMX Address.
6) If no laser outputs from the projector please restart the AC power by turning off the AC switch and
leaving off for 15
seconds and then turning the switch back to the on position.
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Supp
ort at [phone].
LG-40 User Manual 16 11/3/2006/14:01