Instruction Manual

14
Pressing the Power Switch it will show the memory
block number where readings will be stored.
The block number will flash for a few seconds.
(Memory block location is identified by “n” followed
by the block number on the LCD display).
Standard mode allows 24 blocks; each block
can store 10 readings.
Note:
It is not required to use all the memory
blocks; it depends on the application and the
usage of this tachometer.
The Memory Block Indicator will change to Units of Measure
depending if the readings are taken within a certain block.
Unit of Measurement is displayed on the
LCD screen. The upper display indicator
will flash while taking measurements.
The display updates every1 second.
Push the memory button once while holding
the Power Switch to store data in memory.
Caution: Do not hold the memory
button continuously (5 seconds);
this will erase stored readings per
block.