Instruction Manual

19
The stored data in the tachometer can be
recalled each time the memory button is
pressed (M1→M2 etc.). (This is only
applicable to the last Memory block used
and in Standard Mode).
Pressing the Memory Button after M10 will
cycle back the process to M1.
Only the last memory block is accessible
for review. To review all the blocks stored,
it is necessary to download the stored
data using the USB cable and software.
2. Average Mode
When the Power Button is released the
DT-209X stops measuring.
The Memory Button is pressed.
The last measured value is
displayed.
Data for calculations are not
accessible. Only the average
value can be recalled, together with the
LAST, MAX, and MIN readings.
The Memory Button is pressed and then
released.
The maximum measured value is
displayed.
M10
2345
LST
1234
RPM
7200
M
A
X
RPM
1234
LST
1234