Instruction Manual

2
Parts Function
1
USB Connector
Mini-USB connector for PC online measurements and data
downloads.
2
Analog Output
Connector
0 to 1-volt analog output connector for pen recorders and other
external devices.
3
Measurement Mode
Selector Switch
Slide selector switch for different measuring modes. (USB,
Average, STD).
4 Contact Accessories
Contact attachments for contact measurements. Types of
attachments: Funnel, Cone, and FPM wheel (length
measurements).
5 Contact Adapter
Threaded adapter for contact measurements. It can be
installed easily on top of the laser opening. (DT-ADP-200L).
6
Laser Beam
Opening
Output opening for laser diode. (Laser beam Max output: 1
mW. Continuous Wavelength: 670nm).
For Non-contact operation the reflective tape is placed on the
rotating object. When the reflective tape passes the laser a
count is generated.
Effective distance from object to be measured can be from 127
mm to 1.5m (5 inches to 59 inches).
*Measuring Conditions: On reflective surfaces, it may be
necessary to paint the shaft black, to minimize false activation
of the sensor. Reflective tape size and the radius of the
moving object should be considered to get the most accurate
reading from the tachometer.
Warning: Do not look into the laser beam opening while in
operation. Staring at the laser beam directly can cause
eye damage.
7 Display LCD main display 5digits/ Custom Words and Units.
Units of measure are selected from this switch.
Proper contact tip accessory should be used for operation.
Rotation
Speed
Measurement
RPM
Linear Speed
Measurement
M/min-yd/min-ft/min-in/min
8 Unit Selector Switch
Contact
Length
Measurement
(wheel
required)
in /ft/yd/ m