CLS-1455 Series Spinner Flask Instruction Manual Chemglass Life Sciences 3800 North Mill Road Vineland, NJ 08360 USA Phone: 800-843-1794 Email: customer-service@cglifesciences.com Web address: www.cglifesciences.com Rev.
CLS-1455 Series Spinner Flask Instruction Manual Description: The Chemglass Life Sciences spinner systems are designed for long life, high efficiency and low maintenance. Spinners are the ideal environment for culturing a wide variety of cell cultures such as insect cells, hybridomas and many other suspension adapted cells. Features: Dimpled vessel 100mL up to 1L. 3L vessel has flat bottom.
Operating and Assembly Instructions: The cap and magnet assemblies are shipped partially assembled. Glass Rod Installation (refer to Figure 1): Remove the magnet from the magnet holder by pushing the magnet through the holder until free. Next, remove the impeller blade by pulling it free of the magnet holder. Insert the glass shaft into the hole in the bottom of the magnet holder. Insert the silicone plug and then replace the impeller blade and re-install the magnet.
Internal Cap Assembly (refer to Figures 2, 3, 4): Place the white silicone gasket in the inside of the center screw cap and thread the compression fitting body on to the cap stud. Next locate the impeller assembly and cap nut, and then insert the end of the glass shaft in the cap nut and slide the oring over the shaft. Next, loosely screw the cap nut with o-ring and glass shaft (with attached impeller assembly) to the compression fitting body.
100mL, 250mL & 500mL Spinners 100mL, 250mL magnet holder p/n 1451-062 500mL magnet holder p/n 1451-063 1L & 3L Spinners 1L magnet holder p/n 1451-064 3L magnet holder p/n 1430-064 [5] CLS-1455 Spinner Manual CG Life Sciences
Cleaning: Use a commercial cleanser approved for glass. Chemglass Life Sciences recommends item number CLS-4752, 7X™ and 7X-O-Matic® cleaning solutions. Rinse all glassware as soon as possible after use. To decontaminate ware, autoclave contaminated items in water containing cleanser. Disassemble spinner assemblies, compression fittings and paddle assemblies for cleaning and to avoid the trapping of disinfectants and cleansers.
Return Authorization: CGLS must authorize any return of material. Please contact a customer service representative at the correspondence listed below to obtain a Return Merchandise Authorization (RMA) number. The purchaser is responsible for all packing and shipping to CGLS.
