Owner`s manual
TREBLE
-Slide this lever up to increase
the
treble response.
Adjust these levers to give
a
pleasing sound. If a station is
weak
and noisy,
move
TREBLE
down to reduce the noise.
PWR
(Power)
The
PWR
button turns your system on and off.
DNR
@
This is the Dynamic Noise Reduction button.
It
helps remove background
hiss noise from the radio or tape player. You may want
to leave it pushed
in
all the time.
DNR@ is
a
registered trademark
of
National Semiconductor Corporation.
Pushbuttons
The four pushbuttons let
you
return to favorite stations.
You
can
set the pushbuttons for up to eight favorite stations
(4
AM and
4
FM). Just:
Tune
in
the station.
Push
SET. (SET
appears
in
the
VF
display for a few seconds.)
Within
5
seconds, push one of
the
four pushbuttons. Whenever you
push that button, the preset station will return.
Repeat these steps for each pushbutton.
NOTE:
You can preset
3
more stations on each band
by
pushing a pair of buttons
next to each other at the same time.
Just:
Tune in the station.
Push
SET.
(SET appears
in
the VF display for
a
few seconds.)
Within
5
seconds, push two buttons next to each other at the same time.
Whenever
you
push that pair of buttons, the preset station
will
return.
Repeat these steps for each pair of buttons.
Scan Button
When you push this, the radio
will
go to the next station and stay there
a
few seconds. Then
it
will
go to the next station and pause, and keep doing
that. Press
SCAN
again to stop scanning.
Seek
Button
This chooses station also,
but
it
doesn’t keep moving as
SCAN
does. When
you push
SEEK
the
radio goes to the next station and stays there.
3-13