Owner`s manual
Temperature
-
A,
B,
C
The temperature grades are
A
(the highest),
B,
and
C,
representing
the
tire’s
resistance to the generation
of
heat
and its ability to dissipate heat when tested
under controlled conditions on a specified indoor laboratory test wheel.
Sustained high temperature can cause
the
material of the tire to degenerate
and reduce tire life, and excessive temperature can lead to sudden tire failure.
The grade
C
corresponds to a level of performance which all passenger car
tires must meet under the Federal Motor Vehicle Safety Standard
No.
109.
Grades
B
and
A
represent higher levels of performance on the laboratory test
wheel
than
the minimum required
by
law.
Warning: The temperature grade for this tire
is
established for
a
tire that
is
properly inflated and not overloaded. Excessive speed, underinflation, or
excessive loading, either separately or
in
combination, can cause heat
buildup and possible tire failure.
These grades are molded on the sidewalls
of
passenger car tires.
While the tires available as standard or optional equipment on General
Motors vehicles may vary
with
respect to these grades, all such tires meet
General Motors performance standards and have been approved for use on
General Motors vehicles. All passenger type
(P
Metric) tires must conform
to Federal safety requirements
in
addition to these grades.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced carefully
at
the
factory to give you the longest tire life and best overall performance.
In most cases, you
will
not need to have your wheels aligned again.
However,
if
you notice
unusual
tire wear or your vehicle pulling one way or
the other, the alignment may need to be reset. If you notice your vehicle
vibrating when driving on
a smooth road, your wheels may need to be
rebalanced.
Wheel Replacement
Replace
any
wheel that is bent, cracked or badly rusted.
If
wheel nuts keep
coming loose, the wheel, wheel bolts, and wheel nuts should be replaced. If
the wheel leaks air, replace
it
(except some aluminum wheels, which can
sometimes
be
repaired). See
your
GM
dealer
if
any of these conditions exist.
Your dealer will know the kind of wheel you need.
Each new wheel should have the same load carrying capacity, diameter,
width, offset, and be mounted the same way as the one
it
replaces.
6-47