User Guide

Remove the center rubber strips in the crossrails and
attach the GM accessory rack to the nut plates provided
through the center slots (four per crossrail ).
The tap plates can be moved to accommodate various
positions
by sliding them inside the crossrail to the
desired locations before mounting the acccssory rack.
You can adjust the crossrails to handle different sized
loads.
Just loosen the slider knobs at each end of the
crossrail and move them to where you want them. Make
sure both sides
of the crossrail are even. then tighten
the slider knobs.
Be sure the cargo is properly loaded. Follow these guidelines:
Carrying small, heavy loads on the roof is not
recommended.
Tie the load to the moveable tie down (two per each
side of the side rails). Use the crossrails only
to keep
the
load from sliding.
If you need to carry long items, move the crossrails
as far apart as possible. Tie the load to the moveable
tie downs provided in the side rails. Also tie the load
to the bumpers. Do not tie the load so tightly that the
crossrails or side rails are damaged.
2-60