User Guide
Operating the Transmitter
Press and hold
the
appropriate button on the universal
transmitter.
The
red light comes on while the signal is
being transmitted.
Note
that
the effective transmission range of the
universal transmitter may differ from the hand-held
transmitter
and
from one channel to another.
Erasing
Channels
To
erase all three programmed channels. hold down
the two outside buttons
until
the red light begins
to
flash. Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Training
a
Garage Opener
with
a “Rolling
Code” Feature
If
you programmed the universal transmitter,
but
the
garage door
will
not
open. and
if
your
garage
door opener
was manufactured after
1995,
your
garage door may have
a security feature that changes the ”code” of your garage
door opener every time
it
is opened or closed.
To
determine if your garage door opener has this
“rolling code” feature, press the appropriate button on
the universal transmitter that was programmed.
If
the
red light flashes rapidly for
one
to
two seconds. then
turns solid, your ,oarage door opener
has
this feature.
To program a garage door opener with the rolling code
feature, do the following:
1.
2.
3.
3.
5.
6.
Program your hand-held transmitter to the universal
transmitter by following the steps provided under
“Programming
the
Transmitter“ earlier
in
this section.
Remove the cover panel from the garage door opener
receiver.
It
is
located near the garage door opener motor.
Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands.
Press the training button on the garage door opener
receiver for one to two seconds.
Return to your vehicle and press the programmed
button on the universal transmitter until the red light
flashes rapidly (about two seconds).
Release the button. then repress it to confirm
it
was
programmed to
the
garage door opener receiver.
You may now use either
the
universal transmitter or
the hand-held transmitter to open your garage door.
If
you still have difficulty
in
programming and require
assistance, please
call
1-800-355-35
15.
Accessories
Accessories for the universal transmitter are available
from the manufacturer of the unit.
If
you would like
additional information. please call
1-800-355-35
15.
2-66