User Guide
Taillamps
1. Open the endgate.
2.
Remove the two screws
from the lamp assembly.
3.
Pull
the
assembly away from the vehicle.
4.
Turn the socket counterclockwise
to
remove
it.
Push
the tab in while
you
turn the socket
counterclockwise.
5.
Holding
the
base
of
the
bulb, pull the bulb straight
out
of
the socket.
6.
Push the new bulb straight into the socket
until
it clicks.
7.
Put the socket into the lamp assembly and turn the
socket clockwise until it locks into place.
8. Install the lamp assembly and screws.
9.
Close the endgate.
Underhood
Lamp
1.
2.
3.
4.
5.
6.
7.
8.
Disconnect the electrical connector from the
underhood lamp assembly.
Remove the screws.
Disconnect the ground wire.
Remove the lamp assembly from the hood.
Install the
new
bulb.
Replace the assembly. Install and tighten the screws.
Connect
the
ground wire.
Connect the electrical connector
to
the
lamp assembly.