Use And Care Manual

ManualsBrandsChicago Brick Oven ManualsCharcoal GrillsPre-Assembled Hybrid Residential Countertop Oven with Silver Vein Metal Insulating Hood and Natural Gas Package

Parts and Components

The CBO-750 Oven Support Base must:

• be constructed of masonry or metal

• have at least the same area dimensions as the

external footprint of the Oven

You must check with your local Building Department to determine

the amount of clearance required by local building codes between

the Oven and Decorative Cover. CBO recommends you add at least 8

inches for the width (4 inches per side) and 5 inches for the depth

(on the back side of the Oven) to accommodate the Decorative

Cover and Insulation. Also see the Requirements for Clearance

from Combustible Materials section on Page 8 of this manual.

CAUTION: DO NOT USE ANY COMBUSTIBLE MATERIALS

IN THE CONSTRUCTION OF THE COVERING (SHROUD) OF

THE OVEN. ALL BUILDING MATERIALS USED NEAR THE

OVEN, METAL ANCHOR PLATE AND FLUE PIPE SHOULD

BE NONCOMBUSTIBLE AND NEVER MADE OF WOOD.

The Support Base surface must be flat, level and strong enough to

support the total combined weight of the Oven (Hybrid Countertop:

980 lbs | Hybrid DIY: 890 lbs | Hybrid Mobile: 1051 lbs) and the

Decorative Cover design you choose.

The two vertical support feet of the Support Base are typically made

of concrete block. The horizontal Support Base is typically made of a

4-inch-thick, steel-reinforced concrete slab. The standard height of

the horizontal part of the Support Base is 42 inches.

Note: Imagine the Oven’s Support Base as a table. The table’s

legs are concrete blocks and the tabletop is a 4-inch-thick concrete

slab. To build the Support Base, you build the support legs out

of concrete block, then on top of that leg base, you build a frame

to pour a concrete slab (the tabletop). On the concrete slab (the

tabletop), you position the Sub-hearth Insulation Boards, then the

Hearth, then the Oven.

CAUTION: TO AVOID THE POSSIBILITY OF A FIRE,

NONCOMBUSTIBLE MATERIALS MUST BE USED IN

THE CONSTRUCTION OF THE SUPPORT BASE AND ANY

FRAMING USED AROUND THE OVEN.

Support Base

CBO-750 Hybrid Assembly Instructions

CBO-750 OVENS SHOULD BE INSTALLED BY A PROFESSIONAL OR

SUITABLY QUALIFIED INDIVIDUAL.

Anchor Box with

DuraVent Anchor Plate—For

UL-Required Installations

Bolts

Decorative Door

Insulating Blanket

Dome, Hearth (3 pieces)

& Arch

ThermoWorks

Thermometer

18-Gauge Galvannealed

Steel Plate

Cooking Accessories:

Pizza Peel & Brush

Mortar

nsulation Boards