Operation Manual

9
8
Diag. 33 – To tension the safety harness of the Child
Car Seat, pull the adjustment strap G of the harness,
until the harness straps adhere to the child’s body
correctly.
WARNING! Do not over-tighten the harnesses: If
you can insert one nger between the harness and
your child’s shoulders, it means that it is tightened
correctly.
WARNING! Check that the harness is not twisted.
CLEANING AND MAINTENANCE
All cleaning and maintenance operations must only
be carried out by an adult.
HOW TO CLEAN THE FABRIC COVER
The fabric cover of the Child Car Seat can be removed
and cleaned by hand or in a washing machine at 30°C.
Please refer to the following care label symbols for in-
structions on how to clean the fabric cover:
Never use abrasive detergents or solvents. Do not
spin the fabric cover, let it dry without wringing. To
remove the fabric cover, it is rst necessary to re-
move the safety harness. To carry out this operation,
see the points described from Diag. 20 to Diag. 23 in
the “HOW TO ADJUST THE HEIGHT OF THE SAFETY
HARNESS” paragraph:
Once the safety harness has been removed from the
backrest:
Diag. 34 – Take off the fabric cover from the seat of
the Child Car Seat, removing the shoulder straps and
the two harness straps from the respective holes, lo-
cated on the fabric cover.
To replace the fabric cover and harness straps, pro-
ceed as follows:
Diag. 35 – Fit the fabric cover on the seat of the Child
Car Seat, inserting the two harness straps inside
the respective holes, located on the corresponding
points of the fabric cover.
Then carry out the operations described from
Diag. 26 to Diag. 29, in the “HOW TO ADJUST THE
HEIGHT OF THE SAFETY HARNESS” paragraph.
WARNING! Check that the harness is not twisted.
HOW TO CLEAN THE
PLASTIC OR METAL PARTS
Clean the plastic and coated metal parts only with
a damp cloth. Never use abrasive detergents or sol-
vents.
The movable parts of the Child Car Seat must not be
lubricated.
Machine washable at 30°
Do not bleach
Do not spin dry
Do not iron
Do not dry clean
CHECKING THE CONDITION
OF THE COMPONENTS
It is recommended to check regularly the condition
of the following components to ensure that they are
not damaged or worn out:
• Fabric cover: Check that the padding does not
come out from the seams. Check the condition
of the seams: they must always be intact and
undamaged.
• Harness: Check that the fabric weft is not fra-
yed or the harness strap worn out in the parts
corresponding to the adjustment strap, crotch,
shoulders and harness adjustment plate.
• Plastic parts: Check that the plastic parts are not
worn out, damaged or faded.
CAUTION! If the Child Car Seat is deformed or worn
out, it must be replaced: it may no longer comply
with the original safety standards.
STORING THE PRODUCT
When it is not tted into the car, it is recommended
to store the Child Car Seat in a dry place, away from
sources of heat and to protect it from dust, humidity
and direct sunlight.
PRODUCT DISPOSAL
When the Child Car Seat no longer complies with the
original safety standards, stop its use and dispose of
it at an appropriate collection point. Dispose of the
product as laid down in the environmental norms in
force in the Country of use.