Power Screwdriver User Manual

PACHFK1 Installation Instructions
6
2. Orient brackets (A) as shown in figure below. (See Figure 3)
Figure 3
3. Raise and lower brackets (A) until brackets rest against
center stud. (See Figure 3)
NOTE: Front flange on both upper and lower bracket should be
slid behind drywall. (See Figure 5)
Figure 4
Figure 5
4. Make sure upper and lower brackets are level and there is
a minimum of 20.375" between them at bracket centers and
at both ends of brackets.
5. Secure upper and lower brackets to center studs using four
Phillips flat head wood screws (B) at center studs.
(See Figure 6)
6. Secure upper and lower brackets to side studs using
sixteen connector screws (C) and Allen head bit (D)
provided. (See Figure 6)
Figure 6
(A) x 2
2
(A) x 2
Center Stud
Center Stud
3
Front
Flange
On Bracket
Drywall
(B) x 4
(C) x 16
6
6
5