User Manual

8
Repositioning and Relocating the Freezer
• Unplug the power cord from the wall outlet.
• Remove all the food and drinks.
• Securely tape down all loose items inside your Freezer.
• Tape the doors to be closed securely.
• It is recommended that the Freezer stays in the upright position during
transportation. But if it is laid down for transport purpose, please lift it up
immediately after the job is done. Please wait for at least 24 hours before putting the
power.
TROUBLESHOOTING GUIDE
Problem Solution
The freezer has no power
 Power cord isn’t plugged in properly.
 The circuit breaker tripped or a blown fuse.
 Try a different power point.
Compressor runs all the
time
 The room temperature is hotter than normal.
 A large amount of food has been added to the Freezer.
 The door is opened too often.
 The door is not closed completely.
 The temperature control is not set correctly.
 The door gasket does not seal properly.
 The Freezer does not have the correct clearances.
 The Freezer has recently been disconnected for a period
of time. 6+ hours are required for the Freezer to cool
down completely pending on operating conditions.
Temperature inside the
Freezer is too cold.
 Temperature control is set too cold. Turn the control to a
warmer setting and allow several hours for the
temperature to stabilize.
Temperature of external
Freezer side walls are
warm.
 The exterior Freezer walls can be as much as 15-20
degrees warmer than room temperature.
This is normal while the compressor works to transfer
heat from inside the Freezer cabinet to the condenser
behind the Freezer side walls.