Specifications

36

Transmission(MainGearcase)
FluidCheck
Thefillplugislocatedontherearofthegearcase.Accessthefillplugthroughtherightrearwheelwell.
Maintainthefluidlevelatthebottomofthefillplughole.
1. Positionthevehicleonalevelsurface.
2. Removethefillplug.
3. Check
thefluidlevel.
4. Addtherecommendedfluidasneeded.
5. Reinstallthefillplug.
FluidChange
1. Thedrainplugislocatedonthebottomofthegearcase.
2. Removethefillplug.
3. Placeadrainpanunderthedrain plug.
4. Removethedrainplug.Al low
thefluidtodraincompletely.
5. Cleanthedrainplug.
6. ReinstallthedrainplugwithanewO‐ring.
7. Addtherecommendedfluidtothefillplughole.Maintainthefluidlevelatthebottomofthefill
plughole.Donotoverfill.
8. Reinstallthefillplug.
9.
Checkforleaks.
10. Discardusedfluidproperly.
SparkPlugs
SparkPlugGap/Torque
SparkPlugGap PlugTighteningTorque SpecifiedSparkPlug
0.8‐0.9mm(0.032–0.035in.) 12.5ft.lbs.(17.5Nm) DPR7EA‐9(NGK)

NOTICE:Usingnon‐recommendedsparkplugscanresultinseriousenginedamage.Alwaysuseour
companyrecommendedsparkplugs.
Sparkplugconditionis indicativeofengineoperation.Thesparkplugfiringendconditionshouldbe
checkedaftertheengineiswarmedupandthevehicleisdrivenathigherspeeds.
Immediatelycheckthe
sparkplugforcorrectcolor.Ahotexhaustsystemandenginecancauseburns.Wearprotectivegloves
whenremovingasparkplugforinspection.
SparkPlugRemovalandReplacement
1. Removethesparkplugcap.
2. Usingthesparkplugwrenchprovidedinthetoolkit,removethe
plugbyrotatingitcoun ter
clockwise.
3. Reversetheprocedureforsparkpluginstallation.