User manual

Section 3: Operation
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 3-71
020-100001-07 Rev. 1 (11-2009)
Adjustments can now be made to black level controls.
To restore the use of Christie TWIST:
1. Disable black blending.
2. Power cycle the projector.
3. Begin using the TWIST controls.
Black Level Blending Procedure
NOTES: 1) Adjust white levels before adjusting black levels. 2) The zones in BLB
menu correspond to the Edge Blend zones. If a given Edge Blend zone width is set to 0
(i.e. no blend on that side) then the corresponding BLB zone is disabled. It only
becomes accessible when that Edge Blend zone is active.
1. Start with two projectors. Select the black test pattern for both projectors from the
Geometry and Color submenu.
2. In the Black Level Blending submenu, enable black blending by putting a
checkmark in the checkbox for each projector.
3. Working with one projector at a time, use the center brightness slide bar to adjust
the center brightness (brightness of the non-blended region) so that the center
intensity matches that of the brightest blended region (the center of all images
when blending a 2 x 2 display is the target area).
4. Use the following three color slide bars, Black Red Level, Black Green Level and
Black Blue Level, so the black hue of each projector matches.
5. You can choose which of the next four options, Top, Bottom, Left, Right, to use
depending on which edge of the projector you are working with has been edge
blended. The blend width can be adjusted to line up properly but by default it
corresponds to the edge blending setting determined for that edge.