User manual

Section 4: Maintenance
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 4-5
020-100001-07 Rev. 1 (11-2009)
The IR Remote Keypad uses two AA size, 1.5V batteries (preferably alkaline). To
install new batteries:
1) Open the battery
compartment at the backside
of the keypad by placing your
thumb in the oval depression
and sliding the cover out about
½ inch. See Figure 4.1.
Remove the old batteries and
properly discard. Wait a
minute or two.
2) Place the new batteries in
the compartment, orienting the
positive/negative of each
battery according to the labels in the compartment. When the batteries are in place,
replace the cover by placing the cover ½ inch from its closed position and slide it into
place. Do not force the cover.
NOTE: Always wait a minute or two when replacing batteries so that the internal
electronics discharge and can recognize the change.
Use the following instructions when replacing the lamp. The lamp is located at the
back of the projector (below the input panel) and can be accessed by removing the
lamp access panel. Use only the Christie approved Lamp and Filter Kit for your
specific projector model. See Table 4.2 below.
4.3 Replacing
Remote
Batteries
4.4 Lamp and Filter
Replacement
Figure 4.1.Replacing Batteries