User manual

Section 4: Maintenance
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 4-7
020-100001-07 Rev. 1 (11-2009)
1. TURN THE LAMP OFF
Press
(power) to turn the lamp off. Allow the cooling fans to stop
automatically (within approximately five minutes) before proceeding with Step 2.
This wait period is also required to allow the lamp to sufficiently cool before
handling.
2. UNPLUG THE PROJECTOR
When the cooling fans have stopped, turn the projector’s main switch off, and
unplug.
WARNING
Always power down and unplug the projector prior to
servicing. Allow the lamps to cool before handling
3. REMOVE THE LAMP DOOR
WARNING
Protective gear required. Wear a face shield.
Using a #2 Phillips screwdriver,
remove the two (2) screws securing
the lamp door, which is located at
the rear of the projector below the
input panel. See Figure 4.2.
4. RELEASE THE LAMP LOCK
Pull out and turn the lamp lock lever, which is located to the left of the lamp
module, and turn it ¼ turn counter clockwise to the “unlock” position. See Figure
4.3.
Figure 4.2. Open Lamp Doo
r