User manual

Section 4: Maintenance
4-8 Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
020-100001-07 Rev. 1 (11-2009)
Figure 4.3. Release the Lamp Lock
5. REMOVE THE LAMP MODULE
Firmly grasp the lamp by its housing only and pull it straight out (lamp slides
along guides) until it is free. See Figure 4.4. Discard the lamp using safe
disposal/recycling practices.
6. INSERT THE NEW LAMP MODULE
Align the new lamp with the top and bottom guides on the left side of the lamp
compartment (see Figure 4.5). Slide the lamp all the way in – a slightly harder
push may be required right at the end to ensure it is fully seated into the terminal
block.
NOTE: The lamp module must make full contact
with the terminal block. The
projector will not power up again if the lamp is not fully connected to the terminal
block.
Figure 4.4. Remove Lamp Module