User manual

Section 2: Installation and Setup

2-2 Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual

020-100001-07 Rev. 1 (11-2009)

Connect the Line Cord

The North American-rated line cord is provided with each projector. Ensure

that you are using a line cord, socket and power plug that meets the

appropriate local rating standards.

Plug the line cord to the AC receptacle located on the right hand side of the projector

and the three-pronged end into a grounded AC outlet. Ensure the socket outlet is

installed near the equipment and is easily accessible. The input voltage to the

projector must be capable of 100 – 240 VAC in 500W and 1000W models and 200-

240 VAC in 1200W models. (See Section 6 – Specifications for complete details on

all power requirements.)

Use the approved North American-rated line cord supplied with the projector. If you

are connecting to an area outside of North America ensure an appropriately rated line

cord is used.

Turn the Projector ON

Press the

POWER button on either the remote or built-in keypad to turn the

projector on. Wait a few minutes to allow the projector to warm up. The LED status

window displays an active pattern of segments to indicate the projector is changing its

state from powered down to powered up. The message “On” appears in the display

when the projector has completed its initialization and is ready for use.

Select a Source

Press one of the input keys on the remote or built-in keypad to select and display the

image for the source you connected in Step 3.

Adjust Image

Adjust the more common image settings, such as Brightness, Contrast, Gamma,

Focus, Zoom etc. using the direct keys on the IR remote.

You can also access the menu system and adjust these and other image settings by

pressing

on the remote.

Ste

4 

Ste

5 

Ste

6 

Ste

7 