User manual

Section 2: Installation and Setup

Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 2-13

020-100001-07 Rev. 1 (11-2009)

Figure 2.7. Connecting RGB and Sync

NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB

signal, specify this Color Space option within the Image Settings menu. See 3.5

Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV

sources–to

INPUT 1, use the red, green and blue BNCs as described in YPbPr Signals

(below).

Connect an YPbPr signal (component video) to INPUT 1 or INPUT 2 as shown in Figure

2.8.

NOTES: 1) If, for some reason, the projector fails to recognize an YPbPr signal,

specify this Color Space option within the Image Settings menu. See 3.5, Adjusting

the Image. 2) Do not connect digital

component signals (known as YCbCr) to INPUT

. Install an appropriate optional module in INPUT 5 or INPUT 6 for this.

Figure 2.8. Connecting YPbPr sources

YPbPr Signals 

(COMPONENT VIDEO)