User manual

Section 2: Installation and Setup
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 2-17
020-100001-07 Rev. 1 (11-2009)
Figure 2.12. RS232 Network
MIXED NETWORK: To control multiple projectors with a computer/controller having an
RS422 interface, first set them all to the same baud rate as your RS422 controller.
NOTE: You must enable this combination of RS422 and RS232 in the
Communications menu. Set the “Network Routing” option to “RS232 and RS422
Joined”. See Section 3 for details.
Then chain the projectors together by connecting an
RS232 port of the first projector
(already connected to the computer/controller through the
RS422 port) to an RS232
port on the next projector in the chain. Continue connecting projectors in this manner
until you’ve reached the last projector in the chain, so that only the last projector has
one unused
RS232 port.
Note that communication parameters such as baud rate must be set to match the
particular controlling device before connecting as a network—refer to the
documentation that came with your controlling device in order to determine the proper
baud rate. See 3.6, Adjusting System Parameters and Advanced Controls if you need
help changing the projector baud rate. In addition, set the Network Routing to “RS232
and RS422 Joined” if you want to reach all projectors.
NOTES: 1) To avoid damage, connect only properly wired serial communication
cables. See Appendix B for details. 2) It is recommended that each RS232
communication cable be no more than 25 feet in length. Use high quality cables.
ETHERNET NETWORK SETUP: To add one or more projectors to an Ethernet network,
use standard CAT5 cable to connect each projector’s Ethernet port to a hub belonging
to the network. A controller or PC must also be connected to the hub. See Figure 2.13.