User manual

Section 2: Installation and Setup
2-20 Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual
020-100001-07 Rev. 1 (11-2009)
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord, socket and power plug that meets the
appropriate local rating standards.
Plug the line cord to the AC receptacle located at the back of the projector, below the
input panel, and the three-pronged end into a grounded AC outlet. Ensure the socket
outlet is installed near the equipment and is easily accessible. The input voltage to the
projector must be capable of 100 – 240 VAC in 500W and 1000W models and 200-
240VAC in 1200W models. (See also Section 6 – Specifications for complete details
on all power requirements.)
Use the approved North American-rated line cord supplied with the projector. If you
are connecting to an area outside of North America ensure an appropriately line cord
rated for the region of use is used.
Always power down the projector before unplugging the AC line cord. Wait 5-10
minutes for the main exhaust fan to turn off and for the lamp to cool sufficiently
before unplugging the projector.
WARNINGS
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range.
Wait for the cooling fans to turn off before unplugging the
projector.
2.6 Power
Connection