User manual

Section 3: Operation
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 3-39
020-100001-07 Rev. 1 (11-2009)
3D SOURCE — When using a Mirage projector with HD or WUXGA resolution, a
checkbox option called 3D Source will be added to the bottom of the Advanced Image
Settings menu. This checkbox must be set by the user for all new 3D sources, and
cleared for all new non-3D sources (default setting is checked). Once set, this value
will be maintained for that source for all future uses. This option is also available
under the Simulation 3D menu in Mirage HD projectors only.
FLOATING INPUTS - This allows the signals connected to inputs 1, 3, and 4 to have
floating ground references relative to the projector. Floating the inputs can remove
hum bars in the image if the installation has conflicting grounds. However, floating
the inputs can also introduce hum bars when the signal ground is the only connecting
ground. Select the setting that produces the best image.
Use the Configuration menu to define
general operating parameters and
communications with other projectors
and equipment, and to access other
advanced processing and image
adjustments affecting overall
performance. In addition, the
Configuration menu provides access
to diagnostics, calibration tools and
the Service submenu (password-
protected).
Keep in mind that settings in the Configuration menu (and its submenus) are typically
“global” settings applied regardless of the type of source being used. This
characteristic is identified with the
(globe) icon alongside the option.
NOTE: The Configuration menu is recommended for experienced users/technicians
only.
The first six options in the Configuration menu are explained below:
Language
Choose from available languages to use in the projector’s menus. The change will
take effect immediately.
Image Orientation
Set the orientation of the image according to the orientation of your projector. If the
setting is incorrect, projected images will be reversed and/or upside down.
Reserved - No function.
Auto Power-up
Enter a checkmark to enable the projector to automatically power up after losing
power due to a power failure or due to unplugging the projector during operation.
Note that unsaved display adjustments may be lost.
Set Date & Time
Enter/read the current year-month-day and hour-minute-second. Changes here reset
the projector’s real-time clock.
Image Orientation
Auto Power Up
Set Date And Time
Menu Preferences
Communications
Geometry and Color
Diagnostics and Calibration
Service
Option 1 Card: Dual SD/HD-SDI
Language
Reserved
Option Card 2 Empty
1.
2.
3.
4.
5.
6.
7.
8.
9.
0.
English
Front
Configuration
3.6 Adjusting
System
Parameters and
Advanced
Controls
System Configuration 
— GENERAL —