User manual

Section 3: Operation
Mirage S+/HD/WU, Matrix S+/HD/WU, Christie HD/DS+/DW, DLV User Manual 3-43
020-100001-07 Rev. 1 (11-2009)
IP ADDRESS: Enter a valid and unique IP address for use on the network to which the
projector is currently connected. This address will overwrite any previous IP address
such as the projector’s factory-defined default (0.0.0.0), or one that has been assigned
by a DHCP server or other user. It takes approximately 10 seconds for the projector to
respond at its new address.
PORT: On some Ethernet networks, firewall restrictions may require that the port
number of the projector be changed from its default of 3002. If so, enter a new valid
port number here. It is highly recommended not to use a port # below 1024, as these
ports are typically reserved for and used by common IP applications.
SUBNET MASK AND DEFAULT GATEWAY: The Subnet Mask and Default Gateway are
automatically assigned when DHCP is enabled. If a static IP is being used, the IP must
be assigned first since the projector estimates the subnet mask after the IP is entered.
The Default Gateway is an optional router device used to send and receive data
outside the subnet.
NETWORK NAME: Set the name for the projector, as it should appear on the local
network. The control is most useful when DHCP is enabled, since the IP address may
change from one session to another.
ArtNet Interface Settings
— SUBMENU
ArtNet is an Ethernet
communication protocol that
was developed by Artistic
License. It is used for
controlling lighting/staging
equipment from a lighting
console or PC application. It
is based on the popular
DMX512 control protocol.
ArtNet SUBNET: This is the highest level address for a device. Typically it is set to 0.
ArtNet UNIVERSE: Each packet of data is broadcasted to all devices plugged into a
universe (up to 512 devices/channels).
ArtNet ADVANCED MODE: When this setting is enabled, each projector listens for data
on 64 channels starting with the base channel. When advanced mode is not in use, the
projector only listens on 10 channels. You can squeeze more devices per universe
when the projector uses fewer channels.
NOTE: The additional 54 functions are not currently implemented and are reserved
for future use.
1.
2.
3.
4.
5.
6.
ArtNet Subnet
ArtNet Universe
ArtNet Advanced Mode
ArtNet Base Channel
ArtNet Device Name
ArtNet Device Description
00
00
001
Christie
Christie / ArtNet Interface
ArtNet Interface Settings