Setup guide

1-2 CP2210 Setup Guide

020-100524-04 Rev. 1 (05-2014)

Introduction

not exposed to cumulative radiation levels exceeding the government guidelines for your area. 2) Be aware

that some medications are known to increase sensitivity to UV radiation.

This cinema projector must be operated in an environment that meets the operating range specification, as

listed in Section 6 - Specifications from the CP2210 User Manual (020-100410-xx).

1.3 AC/Power Precautions

1) Use only the AC power cord supplied. DO NOT attempt operation if the AC supply is not

within the specified voltage and power range. For details, see Section 6 - Specifications from

the CP2210 User Manual (020-100410-xx).

2) As a safety feature the cinema projector is equipped with a three-wire plug with a third

(grounding) pin. If you are unable to insert the plug into the outlet, contact an electrician to

have the outlet replaced. DO NOT defeat the safety purpose of the grounding-type plug.

3) DO NOT attempt operation if the AC supply is not within the rated voltage range, as

specified on the license label.

4) Disconnect cinema projector from AC before opening any enclosure.

1) DO NOT allow anything to rest on the power cord. Locate the cinema projector where the

cord cannot be abused by persons walking on it or objects rolling over it. Never operate the

cinema projector if the power cable appears damaged in any way.

2) DO NOT overload power outlets and extension cords as this can result in fire or shock

hazards.

3) Note that only qualified service technicians are permitted to open any enclosure on the

product and only if the AC has been fully disconnected from the product.

Power Cords and Attachments

1) The North American rated power cord is provided with each cinema

projector. Ensure that you are using a power cord, socket and power plug that meets the

appropriate local rating standards. 2) Use only an AC power cord recommended by Christie.

Do not attempt operation if the AC supply and cord are not within the specified voltage and

power range.

Use only the attachments and/or accessories recommended by Christie. Use of others may result in the risk of

fire, shock or personal injury.

1.4 Lamp Precautions

EXPLOSION HAZARD! Wear authorized protective safety gear whenever the

lamp door is open! Never attempt to remove the lamp directly after use. The lamp is under

significant pressure when hot and cold, and may explode, causing personal injury and/or

property damage.

Any lamp used in the CP2210 is under high pressure and must be handled with great care at all times. Lamps

may explode if dropped or mishandled.

WARNING

DANGER