Setup guide

2-2 CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Installation and Setup
2.3.3 Adjustable Feet
For many cinema installations, the cinema projector is inclined slightly forward to match screen tilt and to
minimize the amount of vertical offset required. Turn the adjustable feet to increase or decrease the cinema
projector height as needed for proper leveling and/or slight tilt. See Section 2.5 Adjust Tilt and Level the
Cinema Projector for details on how to adjust the feet and how to properly secure the cinema projector.
2.3.4 Lamp Door and Lamps
Located on the back of the cinema projector is the lamp access door designed with a mid-security lock. The
lamp door must remain closed and locked for all normal operation. Lamp replacement should only be
performed by qualified technicians.
The cinema projector is designed to operate with 2.0kW, 1.8kW and 1.4kW lamps.
2.3.5 LED Status Indicators
Located in the rear corners of the cinema projector are two sets of LEDs, which illuminate to provide
continuous feedback of the cinema projector status.
2.3.6 Optional - Motorized Auxiliary Lens Mount (MALM)
The MALM assembly is an optional hardware component, which when needed can be used to switch from flat
to “scope” formats. This assembly can be secured to the cinema projector base and supports either a 1.25x
anamorphic lens or a 1.26x wide converter lens (WCL). The drive and control electronics package for this
motorized accessory lens mount communicates with and is controlled by the cinema projector over a 9-pin
subminiature D cable that connects to the Auxiliary Input Panel.
2.3.7 Projection Lens
A variety of lenses can be used with the CP2210.
2.3.8 Security Locks
Critical internal components and/or connections are protected by various security locks on cinema projector
covers/access panels. This safeguard enables only authorized personnel to access certain restricted areas of the
cinema projector. The cinema projector panels cannot be removed with standard tools unless the key locks are
open.
• Panels with high-security lock: Light Engine and Cardcage
• Panels with low-security lock: Rear Access Door
• No locks: Air Filter Access Panel
2.3.9 Input Panel
• PIB Faceplate Connections
Located on the operator side of the cinema projector (left side) is a communication panel that provides
connection of external devices such as servers and a controller.
• Ethernet: Use the 10Base-T/100Base-TX Ethernet port for network connection to the cinema projector.