Setup guide

Installation and Setup
CP2210 Setup Guide 2-3
020-100524-04 Rev. 1 (05-2014)
• GPIO: Connect external I/O devices, such as the Christie ACT, for remote control of a limited number of
cinema projector functions. See Section 3 Connect Devices to the cinema projector for GPIO pinouts.
• SCCI: A Simple Contact Closure Interface (SCCI) port that provides the following functions upon a simple
dry contact closure: Lamp ON/OFF and Douser Open/Closed.
• RS232 ICP: For direct DLP communication. Trained users required.
• RS232 PIB: Utilizes Christie-proprietary protocol and is intended for Christie accessories or third-party
automation equipment.
• 3D: Connect a variety of 3D products to this connector, such as MasterImage or Real D for polarizing and
de-ghosting 3D content during projection.
• Marriage: Marriage must be established to allow the cinema projector to play encrypted content. This
means the security boundaries SPB1 and SPB2 are physically and electrically connected and that marriage is
monitored 24/7. Marriage is initiated from a Wizard application on the TPC. A user with the appropriate cre-
dentials is prompted to press the Marriage button to establish marriage. If the button is pressed any other
time it is ignored. Marriage cannot be established remotely.
• Emergency Start: This button is recessed into the faceplate to prevent accidental activation. It should only
be used when the TPC has failed or is disconnected. When pressed, the cinema projector is powered on, the
lamp is powered up and the douser is opened. When you press and hold this button, the douser is closed and
the lamp is powered OFF, but power is still ON.
• Reset: This button is slightly recessed into the faceplate to prevent accidental activation. The main purpose
is to reset the electronics of the cinema projector. After re-booting, the cinema projector will return to the
previous power mode (STANDBY or FULL power), however the lamp will not strike automatically and
requires manual striking.
• DVI-A / DVI-B: These are single-link ports for single-link cables/connectors only. The connectors can be
used together as a twin-link DVI port.
• HD-SDI A/HD-SDI-B: Connect a variety of high-definition cinema sources to these SMPTE 292M bit-
serial standard interface BNCs. The connectors can be used together to deliver Dual Link HD-SDI following
the SMPTE 372M standard.
• PIB Faceplate Status Indicators
• STBY: Standby power (Single Color Green) indicates the presence of +24V from the standby power supply.
• OFF: Indicates no standby power (breaker OFF or Standby power failure).
• Green: Indicates standby power.
•PWR: Main power (Single Color Green) indicates the presence of +24V from the Low Voltage Power
Supply (LVPS).
• OFF: No LVPS power (STANDBY mode or breaker OFF).
• Green: Indicates full power.
• RUN: Blinking heartbeat (bi-color green/yellow).
• OFF or Solid Green: Indicates cinema projector not functioning properly.
• Blinking Gr
een: OK (software/communication/OS/ICP/Enigma/IMB if present are operating
normally).
• Solid Yellow: Communication error. NiOS functioning OK, but can no longer communicate with TPC.
• PIB: cinema projector Intelligence Board Status (Bi-color Red/Green)
• OFF: Not detected.
• Red: Detected communication problems etc.
• Blinking Red: PIB card seating error.
• Green: Detected and working properly.
• ICP: Integrated Cinema Processor Status (Bi-color Red/Green)