Setup guide

2-4 CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Installation and Setup
• OFF: Not detected.
• Red: Detected communication problems etc.
• Green: Detected and working properly.
• LD: Link Decrypter (Enigma) Status (Bi-color Red/Green)
• OFF: Not detected.
• Red: Detected communication problems etc.
• Green: Detected and working properly.
• IMB: Image Media Block Status (Bi-color Red/Green)
• OFF: Not detected.
• Red: Detected communication problems etc.
• Green: Detected and working properly.
• ICP Faceplate Connections
The ICP board provides the image processing electronics for the cinema projector. The ICP faceplate includes
a number of LEDs that are only functional when the cinema projector is in full power mode.
• REGEN: (Regulators Enabled) This LED indicates the presence of the internal regulator enable signal.
When illuminated BLUE the internal regulators are enabled. When OFF, not enabled.
• SOFTST: (Software State) This LED indicates the state of the software application. When OFF, in a Fail
state (0). When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
• OSST: (Operating System State) This LED indicates the state of the operating system. When OFF, in a Fail
state (0). When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
• FMTST: (FMT FPGA State) This LED indicates the configured state of the FMT FPGA. When RED,
unable to configure FPGA with Main or Boot application. When YELLOW, in Boot application. When
GREEN, in Main application.
• ICPST: (ICP FPGA State) This LED indicates the configured state of the ICP FPGA. When RED, unable to
configure FPGA with Main or Boot application. When YELLOW, in Boot application. When GREEN, in
Main application.
• Port A / Port B: Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.
• USB 1 / USB 2: For future use.
2.3.10 Touch Panel Controller (TPC)
The TPC is a portable, touch-sensitive screen used to control the cinema projector. It is mounted to the rear of
the cinema projector and can be adjusted at any angle using the flexible double ball joint mount for convenient
viewing and flexible operation in various installation configurations. The TPC provides users with a means for
monitoring operation and status of the cinema projector. Users can turn the lamp ON/OFF, select a specific
source/input and obtain basic status information. Depending on the installation, the TPC can remain mounted
to the cinema projector or wall mounted anywhere else at the site. An optional extension cable is also available,
which can be purchased separately to provide TPC access up to 100 feet away. NOTE: If your system has a
TPC-660E check to ensure the main switch on the back is connected properly. If your system has a TCP-650H
it automatically turns ON when connected.