Setup guide

2-6 CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Installation and Setup
2.5 Adjust Tilt and Level the Cinema Projector
Auto LampLOC
™
must be run any time you move or level the cinema projector.
Disconnect the cinema projector from AC when adjusting the tilt angle or
leveling the cinema projector.
The CP2210 lens should be centered and parallel with the screen. This orientation ensures optimum lens
performance with minimal offset. If this position is not possible (such as when the cinema projector is
significantly higher than the center of the screen), it is better to rely on offset rather than extra tilt.
Use a protractor to measure the degree of screen tilt and then extend or retract the cinema projector feet to
match this angle.
NOTE: The front-to-back tilt of the cinema projector must not exceed 15°.
This limit ensures safe lamp operation and the proper positioning of the
liquid cooling reservoir.
To adjust the vertical or horizontal position of the cinema projector, extend
or retract the adjustable feet on the bottom of the cinema projector by
rotating them. Once the required adjustment is made, tighten the lock nut.
2.6 Install the Touch Panel Controller (TPC)
1. Loosen the mounting arm so that the end fits over the ball joint located
on the rear panel of the cinema projector.
2. Tighten the mounting arm until it fits tightly on the joint.
Figure 2-1 Adjusting
Figure 2-2 Loosen Mounting Arm