Setup guide

2-8 CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Installation and Setup
The lens seals the projection head, preventing contaminants from entering the
main electronics area. Do not operate the cinema projector without a lens installed. Install a
lens plug when you install or transport the cinema projector.
1. Turn the lens clamp to the OPEN position.
2. Remove the two hex screws from the lens mount 2.9.
3. Orient the lens so the lens retaining ring mounts line up with the lens mount.
4. Fully insert the assembly straight into the lens mount opening without turning. Magnets inside the lens
mount help guide the lens into the correct position. A clicking sound indicates the lens has made contact
with the magnets. These magnetic guides ensure the lens is properly seated inside the mount, that the
aperture is orientated correctly and that the connector for motorized zoom and focus is properly connected.
5. Secure the two hex screws and position the lens clamp DOWN to lock the lens assembly in place.
2.9 Install the Optional Anamorphic Lens
Figure 2-5 Insert Lens
Figure 2-6 Lock Lens in Place